Driver Side Seat Belt Warning Light does not Operate
Circuit diagnosis · Vehicles built Jul 2010 – Jun 2012
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012
DESCRIPTION
When the ignition switch is on (IG), the center airbag sensor assembly transmits front seat inner belt state signals to the combination meter assembly through CAN. If the driver seat belt is not fastened, the combination meter assembly blinks the driver seat belt warning light. If the seat belt is fastened, the warning light goes off.- NOTICE:
- The seat belt warning system uses CAN. Before troubleshooting the seat belt warning system, perform "COMMUNICATION FUNCTION CHECK" by following "HOW TO PROCEED WITH TROUBLESHOOTING" to confirm that the communication systems are normal.
WIRING DIAGRAM




INSPECTION PROCEDURE
| 1. CHECK FOR DTCs |
Check for DTCs.
- Result:
Result
Proceed to
Output DTC (CAN communication)
A
Output DTC (Airbag system)
B
No output DTC
C
|
|
||||
|
|
||||
| C | |
| 2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Operate the intelligent tester according to the steps on the display and select "ACTIVE TEST".
- Combination Meter:
Tester Display
Test Part
Control Range
Diagnostic Note
Driver Side Seat Belt
Driver side seat belt warning light
Driver side seat belt warning light is OFF / ON
Confirm that the vehicle is stopped, engine idling
- OK:
- Switch condition (ON/OFF) can be switched by "ACTIVE TEST".
|
|
||||
| OK | ||
| ||
