2007-2013 Highlander Kluger · Service Manual RESTRAINTS

TC and CG Terminal Circuit

Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3.
DTCs are displayed by blinking of the SRS warning light.

HINT:
  1. When each warning light stays blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.
  2. A DTC output mode signal is transmitted through the CAN communication system to each ECU including the center airbag sensor assembly. Thus when all systems do not enter DTC output mode, there may be an ECM malfunction.


WIRING DIAGRAM

C178541E05

INSPECTION PROCEDURE


1. CHECK CAN COMMUNICATION SYSTEM
  1. Use the intelligent tester to check if the CAN communication system is functioning normally.

    HINT:
    1. Refer to "Bus Check" of the CAN communication system (Click here).
    2. The center airbag sensor assembly is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.

    Result:
    Condition
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2. CHECK WIRE HARNESS (TC OF DLC3 - TC OF ECM)

  1. C224072E01
    Turn the ignition switch off.

  1. Disconnect the connector from the ECM.

  1. C178312E03
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    D43-13 (TC) - D31-3 (TC)
    Always
    Below 1 Ω



NG
REPLACE WIRE HARNESS (TC OF DLC3 - TC OF ECM)
OK


3. CHECK WIRE HARNESS (CG OF DLC3 - BODY GROUND)

  1. C224072E02
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    D43-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPLACE WIRE HARNESS (CG OF DLC3 - BODY GROUND)
OK


4. CHECK WIRE HARNESS (TC OF DCL3 - BODY GROUND)

  1. C224072E01
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    D43-13 (TC) - Body ground
    Always
    1 MΩ or higher



NG
REPLACE WIRE HARNESS OR EACH ECU
OK

REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)


← TC and CG Terminal Circuit (May 2007 – Jul 2008)TC and CG Terminal Circuit (Jul 2010 – Jun 2012) →