2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

The Other Caller's Voice cannot be Heard, is too Quiet, or Distorted

Circuit diagnosis · Vehicles built Jul 2010 – Jun 2012

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

INSPECTION PROCEDURE


1. CHECK CELLULAR PHONE
  1. Check if the other caller's voice can be heard properly.

    OK:
    Voice can be heard.

    HINT:
    The purpose of this step is to inspect the cellular phone when it is not connected to the vehicle.



NG
REPAIR OR REPLACE CELLULAR PHONE
OK


2. CHECK NAVIGATION SYSTEM
  1. Check that navigation sound can be heard from the front speaker.

    OK:
    Navigation sound can be heard.



NG
GO TO "VOICE GUIDANCE DOES NOT FUNCTION" IN PROBLEM SYMPTOMS TABLE (Click here)
OK


3. CHECK SETTINGS
  1. Enter the "Call" screen.

  1. E190577E04
    Check if the volume level is not set to low.

    OK:
    The level is not set to low.

    Text in Illustration 
    *a
    Example



NG
SET VOLUME TO HIGH
OK


4. CHECK SETTINGS (OPERATION CHECK)

  1. E176560
    Enter the "Hands-free Volume Setting" screen (Check Hands-free Volume Setting) (Click here).

  1. Check if the "Receive Voice Level" is set to "0".

    HINT:
    The "Receive Voice Level" can be set to 11 different levels, -5 to +5, with a 3 dB difference.

  1. Check if the "Receive Voice Level" is set to the minimum or maximum level.

    HINT:
    When the "Receive Voice Level" is set to the minimum or maximum level, the sound may be distorted.

    OK:
    The "Receive Voice Level" is set to "0".



NG
SET RECEIVE VOICE LEVEL TO "0"
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← The Other Caller's Voice cannot be Heard, is too Quiet, or Distorted (Aug 2008 – Jun 2010)The Other Caller's Voice cannot be Heard, is too Quiet, or Distorted (from Jul 2012) →