2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

The Other Caller's Voice cannot be Heard, is too Quiet, or Distorted

Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

INSPECTION PROCEDURE


1. CHECK CELLULAR PHONE
  1. Check if the voice on the other side can be heard using a cellular phone.

    OK:
    Voice can be heard.



NG
REPAIR OR REPLACE CELLULAR PHONE
OK


2. CHECK NAVIGATION SYSTEM
  1. Check that navigation sound can be heard from the driver side speaker.

    OK:
    Audio sound can be heard.



NG
GO TO "VOICE GUIDANCE DOES NOT FUNCTION" IN PROBLEM SYMPTOMS TABLE (Click here)
OK


3. CHECK SETTINGS

  1. E120109E02
    Check if the volume level is set to low on the "CALL" screen.

    OK:
    The level is not set low.



NG
SET VOLUME TO HIGH
OK


4. CHECK SETTINGS

  1. E120069E02
    Enter the "Handsfree Voice Quality Set" mode (Click here).

  1. Check if the Receive Voice Level is set to "0".

    HINT:
    The Receive Voice Level can be set to 11 different levels, -5 to +5, with a 3 dB difference.

  1. Check if the Receive Voice Level is set to the minimum or maximum level.

    HINT:
    When the Receive Voice Level is set to the minimum or maximum level, the sound may be distorted.

    NOTICE:
    "Voice Quality Type" should not be changed.

    OK:
    The Receive Voice Level is set to "0".



NG
SET RECEIVE VOICE LEVEL TO "0"
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← The Other Caller's Voice cannot be Heard, is too Quiet, or Distorted (May 2007 – Jul 2008)The Other Caller's Voice cannot be Heard, is too Quiet, or Distorted (Jul 2010 – Jun 2012) →