2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

The Other Caller cannot Hear Your Voice, or Your Voice is too Quiet or Distorted

Circuit diagnosis · Vehicles built Jul 2010 – Jun 2012

Versions by build date: Jul 2010 – Jun 2012 from Jul 2012

INSPECTION PROCEDURE


1. CHECK CELLULAR PHONE
  1. Check if the other caller can hear your voice properly.

    OK:
    Your voice can be heard properly.

    HINT:
    The purpose of this step is to inspect the cellular phone when it is not connected to the vehicle.



NG
REPLACE CELLULAR PHONE
OK


2. CHECK SETTINGS

  1. E176577E11
    Check if the Mute switch is set to on.

    OK:
    Mute switch is not set to on.

Text in Illustration 
*a
Example


NG
TURN MUTE SWITCH OFF
OK


3. CHECK MICROPHONE AND VOICE RECOGNITION (OPERATION CHECK)

  1. E187218E08
    Enter the "Microphone & Voice Recognition Check" screen. Refer to Check Mic & Voice Recognition in Operation Check (Click here).

  1. When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

  1. Push the recording switch and perform voice recording.

    HINT:
    1. Select the recording switch with the blower motor of the air conditioning system stopped. If an outlet of the air conditioning system is facing the microphone, noise may be recorded.
    2. Voice can be recorded up to 5 seconds.

  1. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

    OK:
    All check results are normal.

Text in Illustration 
*a
Microphone Input Level Meter
*b
Recording Switch
*c
Stop Switch
*d
Play Switch
*e
Recording Indicator


NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)


← The Other Caller's Voice cannot be Heard, is too Quiet, or Distorted (from Jul 2012)The Other Caller cannot Hear Your Voice, or Your Voice is too Quiet or Distorted (from Jul 2012) →