2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

The Other Caller's Voice cannot be Heard, is too Quiet, or Distorted

Circuit diagnosis · Vehicles built from Jul 2012

Versions by build date: Jul 2010 – Jun 2012 from Jul 2012

INSPECTION PROCEDURE


1. CHECK CELLULAR PHONE
  1. Check if the other caller's voice can be heard properly.

    OK:
    Voice can be heard.

    HINT:
    The purpose of this step is to inspect the cellular phone when it is not connected to the vehicle.



NG
REPAIR OR REPLACE CELLULAR PHONE
OK


2. CHECK NAVIGATION SYSTEM
  1. Check that navigation sound can be heard from the front speaker.

    OK:
    Sound can be heard from the navigation system.



NG
GO TO "VOICE GUIDANCE DOES NOT FUNCTION" IN PROBLEM SYMPTOMS TABLE (Click here)
OK


3. CHECK SETTINGS

  1. E176576E11
    Check if the volume level is set to low on the "Call" screen.

    OK:
    The level is not set to low.

Text in Illustration 
*a
Example


NG
SET VOLUME TO HIGH
OK


4. CHECK SETTINGS (OPERATION CHECK)

  1. E223325
    Enter the "Hands-free Volume Setting" screen. Refer to Check Hands-free Volume Setting in Operation Check (Click here).

  1. Check if the Receive Voice Level is set to "0".

    HINT:
    The Receive Voice Level can be set to 11 different levels, -5 to +5, with a 3 dB difference.

  1. Check if the Receive Voice Level is set to the minimum or maximum level.

    HINT:
    When the Receive Voice Level is set to the minimum or maximum level, the sound may be distorted.

    OK:
    The Receive Voice Level is set to "0".



NG
SET RECEIVE VOICE LEVEL TO "0"
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← The Other Caller's Voice cannot be Heard, is too Quiet, or Distorted (Jul 2010 – Jun 2012)The Other Caller cannot Hear Your Voice, or Your Voice is too Quiet or Distorted (Jul 2010 – Jun 2012) →