2007-2013 Highlander Kluger · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT FUEL SENDER GAUGE ASSEMBLY

  1. A175693E01
    Remove the fuel sender gauge assembly.

  1. Check the operation of the float moving smoothly between F and E.

  1. Measure the resistance between terminals 2 (FE) and 3 (FS) of the connector according to the value(s) in the table below.

    OK:
    Float Level
    Resistance (Ω)
    F
    3.0 to 5.0
    E
    109.0 to 111.0

    HINT:
    If the value is not as specified, replace the fuel sender gauge assembly.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →