2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Display Signal Circuit between Television Camera ECU and Television Camera Assembly

Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010

DESCRIPTION

This is the display signal circuit of the television camera.

WIRING DIAGRAM

E153691E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (TELEVISION CAMERA ECU - TELEVISION CAMERA)

  1. E143742E69
    Disconnect television camera ECU connector N15.

  1. E150736E06
    Disconnect television camera connector S1.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    N15-40 (CB+) - S1-4 (CB+)
    Always
    Below 1 Ω
    N15-39 (CGND) - S1-3 (CGND)
    Below 1 Ω
    N15-20 (CV+) - S1-2 (CV+)
    Below 1 Ω
    N15-19 (CV-) - S1-1 (CV-)
    Below 1 Ω
    N15-40 (CB+) - Body ground
    10 kΩ or higher
    N15-39 (CGND) - Body ground
    10 kΩ or higher
    N15-20 (CV+) - Body ground
    10 kΩ or higher
    N15-19 (CV-) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. INSPECT TELEVISION CAMERA ECU
  1. Reconnect television camera ECU connector N15.

  1. E149957E05
    Measure the voltage of the camera.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    N15-40 (CB+) - N15-39 (CGND)
    Ignition switch on (IG), shift lever in reverse position
    Approx. 6 V



NG
REPLACE TELEVISION CAMERA ECU (Click here)
OK


3. INSPECT TELEVISION CAMERA ASSEMBLY
E150777E02
  1. Reconnect television camera connector S1.

  1. Check the waveform of the television camera using an oscilloscope.

    OK:
    Waveform is as shown in the illustration.

    Item
    Content
    Terminal No. (Symbols)
    S1-2 (CV+) - S1-1 (CV-)
    Tool
    0.2 V/DIV., 0.2 μsec./DIV.
    Condition
    Ignition switch on (IG), shift lever reverse position



NG
REPLACE TELEVISION CAMERA ASSEMBLY (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Display Signal Circuit between Television Camera ECU and Television Camera Assembly (May 2007 – Jul 2008)Display Signal Circuit between Television Camera ECU and Navigation Receiver Assembly (May 2007 – Jul 2008) →