2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Display Signal Circuit between Television Camera ECU and Navigation Receiver Assembly

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010

DESCRIPTION

This is the display signal circuit from the television camera ECU to the navigation receiver assembly.

WIRING DIAGRAM

E150797E02

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEVISION CAMERA ECU)

  1. E149947E02
    Disconnect navigation receiver assembly connector E21.

  1. Disconnect television camera ECU connector N21.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E21-1 (GVI+) - N21-1 (GVO+)
    Always
    Below 1 Ω
    E21-2 (GVI-) - N21-2 (GVO-)
    Below 1 Ω
    E21-3 (GVG1) - N21-3 (GVG1)
    Below 1 Ω
    E21-1 (GVI+) - Body ground
    10 kΩ or higher
    E21-2 (GVI-) - Body ground
    10 kΩ or higher
    E21-3 (GVG1) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Display Signal Circuit between Television Camera ECU and Television Camera Assembly (Aug 2008 – Jun 2010)Display Signal Circuit between Television Camera ECU and Navigation Receiver Assembly (Aug 2008 – Jun 2010) →