REMOVAL
Removal / installation · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 2.
REMOVE BATTERY
|
 |
- Loosen the nut, and disconnect the negative battery terminal.
- CAUTION:
- Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
Remove the nut, and separate the positive battery terminal cable.
Loosen the nut, and remove the bolt and battery clamp.
Remove the battery and battery tray.
| 3.
REMOVE COOL AIR INTAKE DUCT SEAL
|
 |
- Remove the 11 clips and cool air intake duct seal.
| 4.
REMOVE NO. 2 AIR CLEANER INLET
|
 |
- Disconnect the 2 vacuum switching valve clamps.
Disconnect the 2 vacuum hoses.
Remove the 2 bolts and No. 2 air cleaner inlet.
| 5.
REMOVE NO. 1 AIR CLEANER INLET
|
 |
- Disconnect the 2 vacuum hoses, and remove the 2 bolts and No. 1 air cleaner inlet.
| 6.
REMOVE AIR CLEANER CAP SUB-ASSEMBLY
|
 |
- Disconnect the 3 vacuum hoses.
- Loosen the No. 1 air cleaner hose clamp.
Disconnect the hose clamps and No. 2 ventilation hose.
Disconnect the mass air flow meter connector.
- Release the 2 clips, and remove the 2 bolts.
Remove the air cleaner cap sub-assembly and air cleaner filter element.
| 7.
REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
|
| 8.
REMOVE AIR CLEANER CASE SUB-ASSEMBLY
|
 |
- Remove the 3 bolts, disconnect the hose and the connector, and remove the air cleaner case sub-assembly.
| 9.
REMOVE AIR CLEANER BRACKET
|
 |
- Remove the 2 bolts and air cleaner bracket.
| 10.
REMOVE SPEED SENSOR (NT SENSOR) |
 |
- Disconnect the speed sensor connector.
Remove the bolt and speed sensor.
| 11.
REMOVE SPEED SENSOR (NC SENSOR) |
 |
- Disconnect the speed sensor connector.
Remove the bolt and speed sensor.