2007-2013 Highlander Kluger · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE BATTERY

  1. A171858
    Loosen the nut, and disconnect the negative battery terminal.

    CAUTION:
    Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Remove the nut, and separate the positive battery terminal cable.

  1. Loosen the nut, and remove the bolt and battery clamp.

  1. Remove the battery and battery tray.


3. REMOVE COOL AIR INTAKE DUCT SEAL

  1. A170196
    Remove the 11 clips and cool air intake duct seal.


4. REMOVE NO. 2 AIR CLEANER INLET

  1. A170453
    Disconnect the 2 vacuum switching valve clamps.

  1. Disconnect the 2 vacuum hoses.

  1. Remove the 2 bolts and No. 2 air cleaner inlet.


5. REMOVE NO. 1 AIR CLEANER INLET

  1. A170454
    Disconnect the 2 vacuum hoses, and remove the 2 bolts and No. 1 air cleaner inlet.


6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

  1. A170887
    Disconnect the 3 vacuum hoses.

  1. A170447
    Loosen the No. 1 air cleaner hose clamp.

  1. Disconnect the hose clamps and No. 2 ventilation hose.

  1. Disconnect the mass air flow meter connector.

  1. A170451
    Release the 2 clips, and remove the 2 bolts.

  1. Remove the air cleaner cap sub-assembly and air cleaner filter element.


7. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

  1. A170450
    Remove the 3 bolts, disconnect the hose and the connector, and remove the air cleaner case sub-assembly.


9. REMOVE AIR CLEANER BRACKET

  1. A171820
    Remove the 2 bolts and air cleaner bracket.


10. REMOVE SPEED SENSOR (NT SENSOR)

  1. C090569
    Disconnect the speed sensor connector.

  1. Remove the bolt and speed sensor.


11. REMOVE SPEED SENSOR (NC SENSOR)

  1. C090570
    Disconnect the speed sensor connector.

  1. Remove the bolt and speed sensor.

← REMOVAL (Aug 2008 – Jun 2010)INSPECTION (from May 2007) →