2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT AUTOMATIC LIGHT CONTROL SENSOR

  1. B109993E42
    Disconnect the F1 automatic light control sensor connector.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    F1-6 (CLTB) - F1-3 (CLTE)
    Ignition switch off
    Below 1 V
    Ignition switch on (IG)
    10 to 14 V

    Standard resistance:
    Tester Connection
    Specified Condition
    F1-3 (CLTE) - Body ground
    Below 1 Ω

    If the result is not as specified, there may be a malfunction on the wire harness side.

  1. E142674E01
    Reconnect the automatic light control sensor connector.

  1. Connect an oscilloscope to the automatic light control sensor connector.

  1. B113714E01
    Check the waveform.

    OK:
    Tester Connection
    Tool Setting
    Condition
    Specified Condition
    F1-3 (CLTE) - F1-5 (CLTS)
    5 V/DIV., 5 ms./DIV
    Ignition switch on (IG), light control switch in AUTO
    Correct waveform is as shown

    HINT:
    If the ambient light becomes brighter, width A becomes narrower.

    If the result is not as specified, replace the automatic light control sensor.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →