2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY
(Click here)

2. REMOVE NO. 1 HEATER TO REGISTER DUCT

  1. B168378
    Remove the 3 screws <E> and the No. 1 heater to register duct.


3. REMOVE NO. 4 HEATER TO REGISTER DUCT

  1. B168379
    Remove the 3 screws <E> and the No. 4 heater to register duct.


4. REMOVE SIDE NO. 1 DEFROSTER NOZZLE DUCT

  1. B168380
    Remove the screw <E> and the side No. 1 defroster nozzle duct.


5. REMOVE SIDE NO. 2 DEFROSTER NOZZLE DUCT

  1. B168381
    Remove the screw <E> and the side No. 2 defroster nozzle duct.


6. REMOVE DEFROSTER NOZZLE ASSEMBLY

  1. B173016
    Remove the clip.

  1. Remove the 3 screws <E> and the defroster nozzle assembly.


7. REMOVE AUTOMATIC LIGHT CONTROL SENSOR
  1. Disconnect the connector.

  1. E150082
    Disengage the 2 claws and remove the automatic light control sensor.

← REMOVAL (Aug 2008 – Jun 2010)INSPECTION (from May 2007) →