2007-2013 Highlander Kluger · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from May 2007


1. INSTALL ACCELERATOR PEDAL ASSEMBLY

NOTICE:
  1. Avoid physical shock to the accelerator pedal assembly.
  2. Do not disassemble the accelerator pedal assembly.
  3. The accelerator pedal assembly does not require lubrication.
  4. Do not apply oil or other lubricants to the accelerator pedal assembly. If applied, the accelerator pedal assembly must be replaced.

  1. A171724E01
    Install the accelerator pedal assembly with the 2 nuts.

    Torque:
    4.9 N*m{ 50 kgf*cm , 43 in.*lbf }

  1. Connect the accelerator pedal assembly connector.

← REMOVAL (from May 2007)COMPONENTS (from May 2007) →