2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

58-10 Gyro Error

Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010

Also covers:

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010

DESCRIPTION

DTC No.
DTC Detection Condition
Trouble Area
58-10
Ground short, power supply short, or open circuit in the gyro signal
  1. Gyro sensor
  2. Navigation receiver assembly
80-10
Ground short, power supply short, or open circuit in the gyro signal

INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs.


1. CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)

  1. E120088
    Enter the "Navigation Check" mode (Vehicle Sensors) (Click here).

  1. Check the gyro voltage.

    Standard voltage:
    0.1 to 4.5 V



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


2. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3. RECHECK FOR DTC
  1. Recheck for DTCs and check if the same trouble occurs again.

    HINT:
    If DTCs are detected frequently, replace the navigation receiver assembly.

    OK:
    Malfunction disappears.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

END


← 58-10 Gyro Error (+ 80-10) (May 2007 – Jul 2008)58-11 GPS Receiver Error (+ 80-11) (May 2007 – Jul 2008) →