2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

58-40 GPS Antenna Error

Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008

Also covers:

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010

DESCRIPTION

DTC No.
DTC Detection Condition
Trouble Area
58-40
GPS antenna error
  1. Wire harness
  2. GPS antenna
  3. Navigation receiver assembly
58-41
Error of the power source to the GPS antenna
80-40
GPS antenna error
80-41
Error of the power source to the GPS antenna

INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs.


1. CHECK HARNESS AND CONNECTOR (GPS ANTENNA - NAVIGATION RECEIVER ASSEMBLY)
  1. Check that the GPS antenna cord is securely connected to the navigation receiver assembly connector.

    OK:
    The cord is securely connected.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. REPLACE GPS ANTENNA
  1. Replace the GPS antenna with a normal one and check if the same problem occurs again (Click here).

    1. Clear the DTCs (Click here).

    2. Recheck for DTCs and check if the same trouble occurs again.

      OK:
      The same problem does not occur.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

END


← 58-11 GPS Receiver Error (+ 80-11) (Aug 2008 – Jun 2010)58-40 GPS Antenna Error (+ 58-41, 80-40, 80-41) (Aug 2008 – Jun 2010) →