2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


INSPECT LIGHT CONTROL RHEOSTAT
  1. Disconnect the connector from the light control rheostat.

  1. E152418E02
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D3-1 (E) - D3-3 (RV)
    Turn the light control rheostat knob fully downwards
    Below 1 Ω
    D3-1 (E) - D3-3 (RV)
    Turn the light control rheostat knob downwards to upwards
    The value changes gradually (Between below 1 to 8 kΩ)
    D3-1 (E) - D3-3 (RV)
    Turn the light control rheostat knob fully upwards
    8 to 12 kΩ
    D3-5 (TC) - D3-7 (T)
    Turn the light control rheostat knob fully upwards (Tail cancel ON)
    8 kΩ or higher
    D3-5 (TC) - D3-7 (T)
    Turn the light control rheostat knob fully downwards
    Below 1 Ω

    HINT:
    If the value is not as specified, replace the light control rheostat (Click here).

← INSPECTION (May 2007 – Jul 2008)INSPECTION (from Jul 2010) →