INSPECTION
Inspection · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| INSPECT LIGHT CONTROL RHEOSTAT |
Disconnect the connector from the light control rheostat.
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
D3-1 (E) - D3-3 (RV)
Turn the light control rheostat knob fully downwards
Below 1 Ω
D3-1 (E) - D3-3 (RV)
Turn the light control rheostat knob downwards to upwards
The value changes gradually (Between below 1 to 8 kΩ)
D3-1 (E) - D3-3 (RV)
Turn the light control rheostat knob fully upwards
8 to 12 kΩ
D3-5 (TC) - D3-7 (T)
Turn the light control rheostat knob fully upwards (Tail cancel ON)
8 kΩ or higher
D3-5 (TC) - D3-7 (T)
Turn the light control rheostat knob fully downwards
Below 1 Ω
- HINT:
- If the value is not as specified, replace the light control rheostat (Click here).
