2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

5C-40 Camera Picture Error

Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010

DESCRIPTION

DTC
DTC Detection Condition
Trouble Area
5C-40
Synchronous signals from the camera cannot be transmitted.
  1. Wire harness
  2. Television camera ECU
  3. Television camera

WIRING DIAGRAM

E153691E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (TELEVISION CAMERA ECU - TELEVISION CAMERA)

  1. E143742E69
    Disconnect television camera ECU connector N15.

  1. E150736E06
    Disconnect television camera connector S1.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    N15-40 (CB+) - S1-4 (CB+)
    Always
    Below 1 Ω
    N15-39 (CGND) - S1-3 (CGND)
    Below 1 Ω
    N15-20 (CV+) - S1-2 (CV+)
    Below 1 Ω
    N15-19 (CV-) - S1-1 (CV-)
    Below 1 Ω
    N15-40 (CB+) - Body ground
    10 kΩ or higher
    N15-39 (CGND) - Body ground
    10 kΩ or higher
    N15-20 (CV+) - Body ground
    10 kΩ or higher
    N15-19 (CV-) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. INSPECT TELEVISION CAMERA ECU

  1. E149957E05
    Reconnect television camera ECU connector N15.

  1. Measure the voltage of the camera.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    N15-40 (CB+) - N15-39 (CGND)
    Ignition switch on (IG), shift lever in reverse position
    Approx. 6 V



NG
REPLACE TELEVISION CAMERA ECU (Click here)
OK


3. INSPECT TELEVISION CAMERA ASSEMBLY
E150777E02
  1. Reconnect television camera connector S1.

  1. Check the waveform of the television camera using an oscilloscope.

    OK:
    Waveform is as shown in the illustration.

    Item
    Content
    Terminal No. (Symbols)
    S1-2 (CV+) - S1-1 (CV-)
    Tool
    0.2 V/DIV., 0.2 μsec./DIV.
    Condition
    Ignition switch on (IG), shift lever reverse position



NG
REPLACE TELEVISION CAMERA ASSEMBLY (Click here)
OK

REPLACE TELEVISION CAMERA ECU (Click here)


← ADJUSTMENT (Aug 2008 – Jun 2010)5C-40 Camera Picture Error (Aug 2008 – Jun 2010) →