2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

AVC-LAN Circuit

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010

DESCRIPTION

Each unit of the navigation system connected to the AVC-LAN (communication bus) transfers switch signals by the audio visual communication local area network.
If a short to +B or short to ground occurs in this AVC-LAN, the navigation system will not function normally as communication is stopped.

INSPECTION PROCEDURE


1. INSPECT NAVIGATION RECEIVER ASSEMBLY
E153731E01
  1. Disconnect navigation receiver assembly connector E2.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E2-9 (TX+) - E2-10 (TX-)
    Always
    60 to 80 Ω



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR

HINT:
For details of the connectors, refer to "TERMINALS OF ECU" (Click here).

  1. Referring to the AVC-LAN wiring diagram below, check all AVC-LAN circuits.

    1. Disconnect all connectors in all AVC-LAN circuits.

    2. Check for an open or short in all AVC-LAN circuits.E153704E01

      OK:
      There is no open or short circuit.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT MALFUNCTIONING PARTS
  1. Disconnect and reconnect each slave unit one by one until the master unit returns to normal operation.

    HINT:
    1. Check all slave units.
    2. Replace the slave unit that when disconnected, returns the master unit to normal operation.

    OK:
    Master unit returns to normal operation.



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE MALFUNCTIONING PARTS


← Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter (from Jul 2010)AVC-LAN Circuit (Aug 2008 – Jun 2010) →