2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter

Circuit diagnosis · Vehicles built from Jul 2010

DESCRIPTION

The stereo jack adapter assembly sends an external device sound signal to the navigation receiver assembly through this circuit.
The sound signal that has been sent is amplified by the navigation receiver assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the navigation receiver assembly or speakers.

WIRING DIAGRAM

E214557E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the E2 navigation receiver assembly connector.

  1. Disconnect the E22 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E2-19 (AUXI) - E22-4 (AUXO)
    Always
    Below 1 Ω
    E2-18 (AGND) - E22-5 (AGND)
    Always
    Below 1 Ω
    E2-15 (ARI) - E22-2 (ARO)
    Always
    Below 1 Ω
    E2-17 (ALI) - E22-1 (ALO)
    Always
    Below 1 Ω
    E2-16 (ASGN) - E22-3 (ASGN)
    Always
    Below 1 Ω
    E2-19 (AUXI) - Body ground
    Always
    10 kΩ or higher
    E2-18 (AGND) - Body ground
    Always
    10 kΩ or higher
    E2-15 (ARI) - Body ground
    Always
    10 kΩ or higher
    E2-17 (ALI) - Body ground
    Always
    10 kΩ or higher
    E2-16 (ASGN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Speaker Circuit (from Jul 2010)AVC-LAN Circuit (May 2007 – Jul 2008) →