ON-VEHICLE INSPECTION
Inspection · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| CHECK STEERING EFFORT |
- NOTICE:
- Some service operations affect the SRS airbags. Be sure to read the precautionary notice for the SRS airbags before servicing (Click here).
Stop the vehicle on a level, paved surface and turn the wheels straight ahead.
Disconnect the negative (-) battery cable from the battery.
- CAUTION:
- Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
Remove the steering pad (Click here).
Connect the negative (-) battery cable to the battery.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
Using a torque wrench, check if the steering wheel set nut is properly tightened.
- Torque:
- 50 N*m{ 510 kgf*cm , 37 ft.*lbf }
Start the engine and run it at idle.
Turn the steering wheel 90° to the right and check the steering effort (torque) while turning. Check in the opposite direction using the same method.

- Standard steering effort (Reference):
- 6.5 N*m (66 kgf*cm, 58 in.*lbf) or less
- HINT:
- Check tire type, pressure, and the road surface before making your diagnosis.
Align the front wheels straight ahead.
Disconnect the negative (-) battery cable from the battery.
- CAUTION:
- Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
Torque the steering wheel set nut.
- Torque:
- 50 N*m{ 510 kgf*cm , 37 ft.*lbf }
Install the steering pad (Click here).
Connect the negative (-) battery cable to the battery.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
Clear the DTCs (Click here).
Inspect the SRS warning light (Click here).
