2007-2013 Highlander Kluger · Service Manual STEERING

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


CHECK STEERING EFFORT

NOTICE:
Some service operations affect the SRS airbags. Be sure to read the precautionary notice for the SRS airbags before servicing (Click here).

  1. Stop the vehicle on a level, paved surface and turn the wheels straight ahead.

  1. Disconnect the negative (-) battery cable from the battery.

    CAUTION:
    Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Remove the steering pad (Click here).

  1. Connect the negative (-) battery cable to the battery.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Using a torque wrench, check if the steering wheel set nut is properly tightened.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. Start the engine and run it at idle.

  1. C132536
    Turn the steering wheel 90° to the right and check the steering effort (torque) while turning. Check in the opposite direction using the same method.

    Standard steering effort (Reference):
    6.5 N*m (66 kgf*cm, 58 in.*lbf) or less

    HINT:
    Check tire type, pressure, and the road surface before making your diagnosis.

  1. Align the front wheels straight ahead.

  1. Disconnect the negative (-) battery cable from the battery.

    CAUTION:
    Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Torque the steering wheel set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. Install the steering pad (Click here).

  1. Connect the negative (-) battery cable to the battery.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Clear the DTCs (Click here).

  1. Inspect the SRS warning light (Click here).

← ON-VEHICLE INSPECTION (Aug 2008 – Jun 2010)C1511 Torque Sensor Circuit Malfunction (+ C1512, C1513, C1514) (May 2007 – Jul 2008) →