2007-2013 Highlander Kluger · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from May 2007


CHECK ACCELERATOR PEDAL ASSEMBLY
  1. Check the voltage.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG).

    3. Turn the intelligent tester on.

    4. Select the menu items: Powertrain / Engine and ECT / Data List / Accelerator Position No. 1, Acceleration Position No. 2.

    5. Operate the accelerator pedal assembly, and then check that the Accelerator Position No. 1 and Accelerator Position No. 2 values are within the specifications.

      Standard voltage (Accelerator Position No. 1):
      Accelerator Pedal Assembly Condition
      Specified Condition
      Released
      0.5 to 1.1 V
      Depressed
      2.5 to 4.5 V

      Standard voltage (Accelerator Position No. 2):
      Accelerator Pedal Assembly Condition
      Specified Condition
      Released
      1.2 to 2.0 V
      Depressed
      3.4 to 5.0 V

      If the result is not as specified, check the accelerator pedal assembly, wire harness or ECM.

← COMPONENTS (from May 2007)REMOVAL (from May 2007) →