2007-2013 Highlander Kluger · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. INSTALL NO. 2 ECM BRACKET

  1. A171722E01
    Install the 2 screws and No. 2 ECM bracket.


2. INSTALL NO. 1 ECM BRACKET

  1. A171721E01
    Install the 2 screws and No. 1 ECM bracket.


3. INSTALL ECM

  1. A171720E01
    Install the 2 nuts, bolt and ECM.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Install the wire harness clamp.

  1. Connect the 5 ECM connectors.

  1. Connect the harness connector (LHD).


4. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
  1. Connect each connector and clamp.

  1. B168370
    Engage the 4 claws and 3 clips.

  1. Install the lower instrument panel sub-assembly with the 2 bolts <B> and 3 screws <F>.


5. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

  1. B173000
    Engage the 2 guides.

  1. Engage the 3 claws and install the No. 2 instrument panel under cover sub-assembly.


6. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:
Use the same procedure for the RH side and the LH side (Click here).


7. INSTALL FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure for the RH side and the LH side (Click here).


8. REGISTER IMMOBILISER COMMUNICATION ID

NOTICE:
If the ECM is replaced, register the ECM communication ID for the immobiliser system (Refer to the Service Bulletin for Registration).


9. PERFORM INITIALIZATION

NOTICE:
If the ECM is replaced, perform RESET MEMORY (AT initialization) (Click here).

← REMOVAL (from Jul 2010)INSTALLATION (Aug 2008 – Jun 2010) →