INSTALLATION
Removal / installation · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| 1.
INSTALL ECM |
 |
- Install the 2 ECM brackets to the ECM with the 4 screws.
- Install the ECM with the ECM bracket with the bolt and 2 nuts.
-
Torque:
- for LHD:
- 8.5 N*m{
87 kgf*cm
, 75 in.*lbf
}
- for RHD:
- 8.0 N*m{
82 kgf*cm
, 71 in.*lbf
}
Install the 2 wire harness clamps (for LHD).
Install the wire harness clamp (for RHD).
Connect the 6 ECM connectors.
| 2.
INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
|
 |
Connect each connector and clamp.
- Engage the 4 claws and 3 clips.
Install the lower instrument panel sub-assembly with the 2 bolts <B> and 3 screws <E>.
| 3.
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
|
 |
- Engage the 2 guides.
Engage the 3 claws and install the No. 2 instrument panel under cover sub-assembly.
| 4.
INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH (for LHD)
|
 |
- HINT:
- Use the same procedure for the RH side and the LH side.
| 5.
INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH (for RHD)
|
 |
- Engage the claw and clip, install the cowl side trim sub-assembly LH.
Install the clip.
| 6.
INSTALL FRONT DOOR SCUFF PLATE RH (for LHD)
|
 |
- HINT:
- Use the same procedure for the RH side and the LH side.
| 7.
INSTALL FRONT DOOR SCUFF PLATE LH (for RHD)
|
 |
- Engage the guide and 8 claws, and install the front door scuff plate LH.
| 8.
REGISTER IMMOBILISER COMMUNICATION ID |
 |
- NOTICE:
- If the ECM is replaced, register the ECM communication ID for the immobiliser system (Refer to the Service Bulletin for Registration).
| 9.
PERFORM INITIALIZATION |
 |
- NOTICE:
- If the ECM is replaced, perform RESET MEMORY (AT initialization) (Click here).