2007-2013 Highlander Kluger · Service Manual BODY

DISASSEMBLY

Removal / installation · Vehicles built from May 2007


1. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

  1. B173670
    Remove the 2 bolts and sliding roof drive gear sub-assembly.


2. REMOVE SUNSHADE TRIM SUB-ASSEMBLY

  1. B160460
    Remove the screw and sliding roof piece sub-assembly LH.

    HINT:
    Use the same procedure for the RH side and the LH side.

  1. B152946
    Slide and remove the sunshade trim sub-assembly.


3. REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

NOTICE:
Disassemble the sliding roof drive cable sub-assembly only when replacing it.

  1. B173672
    Remove the screw and sliding roof side stopper.

    HINT:
    Use the same procedure for the RH side and the LH side.

  1. B160476E01
    Using a screwdriver, disengage the 2 claws. Then slide the sliding roof drip channel rearward to remove it.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to remove it.

    B160477E01

← REMOVAL (from Jul 2010)REASSEMBLY (from May 2007) →