2007-2013 Highlander Kluger · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from May 2007


1. INSPECT PACK CLEARANCE OF REVERSE CLUTCH

  1. D026426E02
    Install the intermediate shaft and needle roller bearing onto the transaxle rear cover.

  1. Using a dial indicator, measure the reverse clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).

    Pack clearance:
    0.60 to 0.82 mm (0.0236 to 0.0323 in.)

    If the pack clearance is not as specified, inspect the discs, plates, and flange.


2. INSPECT PACK CLEARANCE OF DIRECT CLUTCH AND OVERDRIVE CLUTCH

  1. D026427E01
    Using a dial indicator, measure the direct clutch and overdrive clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).

    Pack clearance:
    0.61 to 0.83 mm (0.0240 to 0.0327 in.)

    If the pack clearance is not as specified, inspect the discs, plates, and flange.


3. REMOVE DIRECT MULTIPLE CLUTCH DISC

  1. D026419E01
    Using a screwdriver, remove the snap ring from the intermediate shaft.

  1. D026420
    Remove the flange, 3 discs, 3 plates, and cushion plate from the intermediate shaft.


4. REMOVE OVERDRIVE DIRECT CLUTCH DISC

  1. D026422
    Using a screwdriver, remove the snap ring from the intermediate shaft.

  1. Remove the flange, 4 discs, and 4 plates from the intermediate shaft.


5. REMOVE OVERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY

  1. D003677E01
    Place SST on the clutch balancer and compress the spring with a press.
    SST
    09387-00020  

  1. Using a snap ring expander, remove the snap ring from the direct clutch drum.

    NOTICE:
    1. Stop the press when the spring seat is lowered to the place 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove. This prevents the spring seat from being deformed.
    2. Do not expand the snap ring excessively.

  1. D026424E05
    Remove the clutch balancer from the direct clutch drum.

  1. D026423E05
    Remove the overdrive clutch return spring from the direct clutch drum.


6. REMOVE OVERDRIVE DIRECT CLUTCH PISTON

  1. D026463
    Install the intermediate shaft on the transaxle rear cover.

  1. Holding the direct clutch piston by hand, apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) to the transaxle rear cover to remove the direct clutch piston.


7. REMOVE OVERDRIVE DIRECT CLUTCH DRUM SUB-ASSEMBLY

  1. D026425
    Holding the direct clutch drum by hand, apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) to the transaxle rear cover to remove the direct clutch drum.


8. REMOVE OVERDRIVE DIRECT CLUTCH O-RING

  1. D026464E01
    Using a screwdriver, remove the O-ring from the direct clutch drum.

← COMPONENTS (from May 2007)INSPECTION (from May 2007) →