Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Manual Air Conditioning System)
HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
HINT:
Use the following procedures to troubleshoot the air conditioning system.
*: Use the intelligent tester.
1.VEHICLE BROUGHT TO WORKSHOP
NEXT
2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK
NEXT
3.INSPECT BATTERY VOLTAGE
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
NEXT
4.CHECK CAN COMMUNICATION SYSTEM*
Use the intelligent tester to check if the CAN communication system is functioning.
Result:
Result
Proceed to
CAN DTC is not output
A
CAN DTC is output
B (Click here )
B.
A
Check for DTCs.
Write down the DTCs or sensor check codes.
Clear the DTCs or sensor check codes.
Check whether the DTCs or sensor check codes recur.
Reproduce the problem symptoms in accordance with the DTCs or sensor check codes that were written down, and check whether the DTCs or sensor check codes recur.
HINT:
Refer to the DTC chart when any DTCs or sensor check codes are output.
Result:
Result
Proceed to
DTC or sensor check code is not output
A
DTC or sensor check code is output
B
B.
A
6.REFER TO PROBLEM SYMPTOMS TABLE
Result:
Result
Proceed to
Fault not listed in problem symptoms table
A
Fault listed in problem symptoms table
B
B.
A
7.OVERALL ANALYSIS AND TROUBLESHOOTING*
DATA LIST / ACTIVE TEST (Click here )
Terminals of ECU (Click here )
NEXT
8.ADJUST, REPAIR OR REPLACE
NEXT
NEXT