2007-2013 Highlander Kluger · Service Manual HEATER & AIR CONDITIONING SYSTEM

B1443/43 Air Outlet Damper Control Servo Motor Circuit

Diagnostic trouble codes · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The damper servo sends pulse signals to indicate the damper position to the air conditioning amplifier. The air conditioning amplifier activates the motor (normal or reverse) based on these signals to move the mode damper to the appropriate position, which controls the air outlet modes.

HINT:
Confirm that there are no mechanical problems because this DTC can be set if either a damper link or damper is mechanically locked.
DTC No.
DTC Detection Condition
Trouble Area
B1443/43
Air outlet damper position does not change even if air conditioning amplifier operates air outlet damper control servo motor
  1. Air outlet control servo motor
  2. Air conditioning harness
  3. Air conditioning amplifier


WIRING DIAGRAM

E133419E07

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (AIR OUT PULSE)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the intelligent tester main switch on.

  1. Select the item below in the Data List, and read the value displayed on the intelligent tester.

    Data List / Air Conditioner: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Air Out Pulse
    Air outlet servo motor target pulse /
    Min.: 0, Max.: 255
    FACE: 8 (pulse)
    B/L: 30 (pulse)
    FOOT: 67 (pulse)
    FOOT/DEF: 80 (pulse)
    DEF: 97 (pulse)
    -

    OK:
    The display is as specified in the normal condition column.


    Result:
    Result
    Proceed to
    NG
    A
    OK (Checking from PROBLEM SYMPTOMS TABLE)
    B
    OK (Checking from DTC)
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPAIR OR REPLACE AIR CONDITIONING HARNESS
A


2. REPLACE AIR OUTLET CONTROL SERVO MOTOR
  1. Replace air outlet control servo motor (Click here).


NEXT


3. CHECK DTC OUTPUT
  1. Check for DTC.

    OK:
    DTC B1443/43 is not output.



NG
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
OK

END


← B1443/43 Air Outlet Damper Control Servo Motor Circuit (Aug 2008 – Jun 2010)B1447/47 Rear Air Mix Damper Control Servo Motor Circuit (May 2007 – Jul 2008) →