2007-2013 Highlander Kluger · Service Manual BODY

ON-VEHICLE INSPECTION

Inspection · Vehicles built from May 2007


INSPECT DEFOGGER RELAY (Marking: RR DEF)
  1. Remove the defogger relay from the engine room relay block.

  1. B177582E01
    Measure the resistance according to the value(s) in the table below.
    Standard resistance 
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    Voltage is not applied between terminals 1 and 2
    Below 1 Ω
    3 - 4
    Apply battery voltage between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Apply battery voltage between terminals 1 and 2
    Below 1 Ω
    If the result is not as specified, replace the defogger relay.

← ON-VEHICLE INSPECTION (from May 2007)ON-VEHICLE INSPECTION (from May 2007) →