2007-2013 Highlander Kluger · Service Manual SECURITIES

B2796 No Communication in Immobiliser System

Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010

Also covers:

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

These DTCs are output if a key that does not have a transponder chip is inserted into the ignition key cylinder or if communication between the key and transponder key ECU assembly is impossible.
DTC No.
DTC Detection Condition
Trouble Area
B2796
The key code cannot be transmitted
  1. Key
  2. Transponder key amplifier
  3. Transponder key ECU assembly
B2798
Key code identification cannot be completed within the specified time (0.15 to 0.5 sec.)
  1. Key
  2. Transponder key amplifier
  3. Transponder key ECU assembly

WIRING DIAGRAM

B164252E07

INSPECTION PROCEDURE

NOTICE:
  1. If the transponder key ECU is replaced, register the key and ECU communication ID.
  2. If the key is replaced, register the key.


1. READ VALUE ON INTELLIGENT TESTER (IMMOBILISER SYSTEM STATUS)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Turn the tester on.

  1. Select Immobiliser in the Data List and read the tester display.

    Immobiliser (Transponder Key ECU): 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Immobiliser
    Immobiliser system status/SET or UNSET
    UNSET: Ignition switch ON
    SET: Without key
    -

    OK:
    UNSET (Ignition switch ON) appears on the screen.



NG
Go to step 2
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY

2. CHECK KEYS
  1. Insert the vehicle's other key into the ignition key cylinder.

  1. Check that the engine starts with this key.

    OK:
    The engine starts.



NG
Go to step 5
OK


3. RE-REGISTER KEY
  1. Re-register the key.


NEXT


4. CHECK ENGINE START
  1. Check that the engine starts.

    OK:
    The engine starts.



NG
REPLACE KEY
OK

END (PROBLEM WITH KEY REGISTRATION IS DEFECTIVE)

5. REPLACE TRANSPONDER KEY AMPLIFIER
  1. Replace the transponder key amplifier (Click here).


NEXT


6. CHECK ENGINE START
  1. Check that the engine starts.

    OK:
    The engine starts.



NG
REPLACE TRANSPONDER KEY ECU ASSEMBLY
OK

END (TRANSPONDER KEY AMPLIFIER IS DEFECTIVE)


← B2796 No Communication in Immobiliser System (+ B2798) (May 2007 – Jul 2008)B2796 No Communication in Immobiliser System (+ B2798) (from Jul 2010) →