B2796 No Communication in Immobiliser System
Diagnostic trouble codes · Vehicles built from Jul 2010
Also covers:
- B2798 Communication Malfunction No. 2
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
These DTCs are output if a key that does not have a transponder chip is inserted into the ignition key cylinder or if communication between the key and transponder key ECU assembly is impossible.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2796 |
The key code cannot be transmitted |
|
| B2798 |
Key code identification cannot be completed within the specified time (0.15 to 0.5 sec.) |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- If the transponder key ECU is replaced, register the key and ECU communication ID.
- If the key is replaced, register the key.
- If the transponder key ECU is replaced, register the key and ECU communication ID.
| 1. READ VALUE ON INTELLIGENT TESTER (IMMOBILISER SYSTEM STATUS) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester on.
Select Immobiliser in the Data List and read the tester display.
Immobiliser (Transponder Key ECU): Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Immobiliser
Immobiliser system status/SET or UNSET
UNSET: Ignition switch ON
SET: Without key
-
- OK:
- UNSET (Ignition switch ON) appears on the screen.
|
|
||||
| OK | ||
| ||
| 2. CHECK KEYS |
Insert the vehicle's other key into the ignition key cylinder.
Check that the engine starts with this key.
- OK:
- The engine starts.
|
|
||||
| OK | |
| 3. RE-REGISTER KEY |
Re-register the key.
| NEXT | |
| 4. CHECK ENGINE START |
Check that the engine starts.
- OK:
- The engine starts.
|
|
||||
| OK | ||
| ||
| 5. REPLACE TRANSPONDER KEY AMPLIFIER |
Replace the transponder key amplifier (Click here).
| NEXT | |
| 6. CHECK ENGINE START |
Check that the engine starts.
- OK:
- The engine starts.
|
|
||||
| OK | ||
| ||
