B2780 Push Switch / Key Unlock Warning Switch Malfunction
Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
This DTC will be output if the transponder key ECU assembly does not detect that the unlock warning switch is on even when the ignition switch is in the ON position. Under normal conditions, the unlock warning switch is on when the ignition switch is in the ON position.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2780 |
"Unlock warning switch ON" is not detected when ignition switch is ON |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- If the transponder key ECU is replaced, register the key and ECU communication ID.
| 1. READ VALUE ON INTELLIGENT TESTER (UNLOCK WARNING SWITCH) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester on.
Select Key SW in the Data List and read the tester display.
Immobiliser (Transponder Key ECU): Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Key SW
Unlock warning switch signal/ON or OFF
ON: Key is in ignition key cylinder
OFF: No key is in ignition key cylinder
-
- OK:
- ON (Key is in ignition key cylinder) appears on the screen.
|
|
||||
| OK | ||
| ||
| 2. INSPECT UNLOCK WARNING SWITCH ASSEMBLY |
Remove the unlock warning switch assembly (Click here).

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Switch Position
Specified Condition
1 - 2
Switch pushed
(Key inserted)
Below 1 Ω
1 - 2
Switch free
(Key removed)
10 kΩ or higher
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
D16-2 - Body ground
Always
Below 1 Ω
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - UNLOCK WARNING SWITCH) |
Disconnect the transponder key ECU connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
D37-3 (KSW) - D16-1
Always
Below 1 Ω
D16-1 - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
