2007-2013 Highlander Kluger · Service Manual SECURITIES

B2780 Push Switch / Key Unlock Warning Switch Malfunction

Diagnostic trouble codes · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

This DTC will be output if the transponder key ECU assembly does not detect that the unlock warning switch is on even when the ignition switch is in the ON position. Under normal conditions, the unlock warning switch is on when the ignition switch is in the ON position.
DTC No.
DTC Detection Condition
Trouble Area
B2780
"Unlock warning switch ON" is not detected when ignition switch is ON
  1. Wire harness or connector
  2. Unlock warning switch assembly
  3. Transponder key ECU assembly

WIRING DIAGRAM

B151009E09

INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU is replaced, register the key and ECU communication ID.


1. READ VALUE ON INTELLIGENT TESTER (UNLOCK WARNING SWITCH)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Turn the tester on.

  1. Select Key SW in the Data List and read the tester display.

    Immobiliser (Transponder Key ECU): 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Key SW
    Unlock warning switch signal/ON or OFF
    ON: Key is in ignition key cylinder
    OFF: No key is in ignition key cylinder
    -

    OK:
    ON (Key is in ignition key cylinder) appears on the screen.



NG
Go to step 2
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY

2. INSPECT UNLOCK WARNING SWITCH ASSEMBLY

  1. B164411E01
    Remove the unlock warning switch assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Position
    Specified Condition
    1 - 2
    Switch pushed
    (Key inserted)
    Below 1 Ω
    1 - 2
    Switch free
    (Key removed)
    10 kΩ or higher



NG
REPLACE UNLOCK WARNING SWITCH ASSEMBLY (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - BODY GROUND)

  1. B151010E06
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D16-2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - UNLOCK WARNING SWITCH)

  1. B151011E04
    Disconnect the transponder key ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D37-3 (KSW) - D16-1
    Always
    Below 1 Ω
    D16-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY


← B2780 Push Switch / Key Unlock Warning Switch Malfunction (Aug 2008 – Jun 2010)B2784 Antenna Coil Open / Short (May 2007 – Jul 2008) →