B2784 Antenna Coil Open / Short
Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
The transponder key coil is built into the transponder key amplifier and receives a key code signal from the transponder chip in the key. This signal is amplified by the amplifier, then it is output to the transponder key ECU assembly.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2784 |
Antenna coil is open/shorted |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- If the transponder key ECU is replaced, register the key and ECU communication ID.
| 1. READ VALUE ON INTELLIGENT TESTER (TRANSPONDER KEY AMPLIFIER) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester on.
Select Antenna Coil Status in the Data List and read the tester display.
Immobiliser (Transponder Key ECU): Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Antenna Coil Status
Transponder key amplifier coil condition/NORMAL or FAIL
NORMAL: Antenna coil is normal
FAIL: Antenna coil is malfunctioning
-
- OK:
- NORMAL (Antenna coil is normal) appears on the screen.
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER) |
Disconnect the transponder key ECU and transponder key amplifier connectors.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
D37-4 (TXCT) - D24-5 (TXCT)
Always
Below 1 Ω
D37-5 (AGND) - D24-7 (AGND)
Always
Below 1 Ω
D37-14 (VC5) - D24-1 (VC5)
Always
Below 1 Ω
D37-15 (CODE) - D24-4 (CODE)
Always
Below 1 Ω
D37-4 (TXCT) - Body ground
Always
10 kΩ or higher
D37-5 (AGND) - Body ground
Always
10 kΩ or higher
D37-14 (VC5) - Body ground
Always
10 kΩ or higher
D37-15 (CODE) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 3. INSPECT TRANSPONDER KEY ECU ASSEMBLY (TRANSPONDER KEY AMPLIFIER POWER SOURCE) |
Reconnect the transponder key ECU and transponder key amplifier connectors.

Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
D37-14 (VC5) - Body ground
No key is in ignition key cylinder
Below 1 V
D37-14 (VC5) - Body ground
Key is in ignition key cylinder
4.6 to 5.4 V
|
|
||||
| OK | |
| 4. INSPECT TRANSPONDER KEY ECU ASSEMBLY (TRANSPONDER KEY AMPLIFIER GROUND) |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
D37-5 (AGND) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
