REASSEMBLY
Removal / installation · Vehicles built from Jul 2010
| 1.
INSTALL NO. 2 STEERING RACK BOOT |
 |
- Apply lithium soap base glycol grease to the inside of the small opening of a new No. 2 steering rack boot.
Install the No. 2 steering rack boot to the groove on the rack housing.
- NOTICE:
- Be careful not to damage or twist the boot.
- Make sure that the boot is free of rust and foreign matter.
| 2.
INSTALL NO. 1 STEERING RACK BOOT |
 |
- HINT:
- Perform the same procedure as for the No. 2 steering rack boot.
| 3.
INSTALL NO. 2 STEERING RACK BOOT CLAMP |
 |
- Using SST, tighten a new No. 2 steering rack boot clamp, as shown in the illustration.
- SST
- 09521-24010
- Clearance:
- 3.0 mm (0.118 in.) or less
- NOTICE:
- Be careful not to damage or twist the boot.
| 4.
INSTALL NO. 1 STEERING RACK BOOT CLAMP |
 |
- HINT:
- Perform the same procedure as for the No. 2 steering rack boot clamp.
- SST
- 09521-24010
| 5.
INSTALL STEERING RACK BOOT CLIP (for LH Side) |
 |
Using pliers, install the steering rack boot clip.
| 6.
INSTALL STEERING RACK BOOT CLIP (for RH Side) |
 |
- HINT:
- Perform the same procedure as for the LH side.
| 7.
INSPECT STEERING GEAR ASSEMBLY |
 |
- Using SST, rotate the pinion shaft to see if both the left and the right steering rack boots expand and contract smoothly.
- SST
- 09616-00011
- HINT:
- If the operation cannot be done as specified, use a new steering rack boot clamp and reinstall the steering rack boots.