2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built May 2007 – Jun 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. REMOVE TRANSMITTER BATTERY (for RHD)

NOTICE:
Special caution should be taken for handling each component as they are precision electronic components.

  1. B174111
    Using a screwdriver with its tip wrapped with protective tape, pry open the transmitter housing cover.

    NOTICE:
    Do not forcibly pry the cover.

  1. B174112
    Remove the battery (lithium battery).

    NOTICE:
    1. Do not push the terminals with your finger.
    2. Do not forcibly pry up the battery. The terminals may become damaged.
    3. Do not touch the battery with wet hands. Water may cause rust.
    4. Do not touch or move any components inside the transmitter. It may cease to work.


2. REMOVE TRANSMITTER HOUSING COVER (for LHD)

  1. B102249
    Using a screwdriver with its tip wrapped with protective tape, pry open the transmitter housing cover.

    NOTICE:
    Do not forcibly pry the cover.


3. REMOVE DOOR CONTROL TRANSMITTER MODULE (for LHD)

  1. B137124
    Using a screwdriver with its tip wrapped with protective tape, remove the door control transmitter module from the transmitter housing case.

    NOTICE:
    Handle each part with care as they are delicate electrical parts.


4. REMOVE TRANSMITTER BATTERY (for LHD)

  1. B102246
    Twist the coin in the direction of the arrow mark in the illustration, and remove the transmitter battery's cover.

  1. B102247
    Remove the battery (lithium battery: CR2016).

    NOTICE:
    1. Do not push the terminals with your finger.
    2. Do not forcibly pry up the battery. The terminals may become damaged.
    3. Do not touch the battery with wet hands. Water may cause rust.
    4. Do not touch or move any components inside the transmitter. It may cease to work.

← COMPONENTS (from Jul 2010)REMOVAL (from Jul 2010) →