2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. REMOVE TRANSMITTER BATTERY (for LHD)

  1. B221462E01
    Remove the transmitter battery.

    1. Using a screwdriver with its tip wrapped with protective tape, pry open the transmitter hosing case.

  1. B209086
    Remove the transmitter battery (lithium battery: CR2032) from the transmitter hosing cover.

    NOTICE:
    1. Do not push the terminals with your finger.
    2. Do not forcibly pry up the battery. The terminals may become damaged.
    3. Do not touch the battery with wet hands. Water may cause rust.
    4. Do not touch or move any components inside the transmitter. It may cease to work.


2. REMOVE TRANSMITTER BATTERY (for RHD)

NOTICE:
Special caution should be taken for handling each component as they are precision electronic components.

  1. B174111
    Using a screwdriver with its tip wrapped with protective tape, pry open the transmitter housing cover.

    NOTICE:
    Do not forcibly pry the cover.

  1. B174112
    Remove the battery (lithium battery).

    NOTICE:
    1. Do not push the terminals with your finger.
    2. Do not forcibly pry up the battery. The terminals may become damaged.
    3. Do not touch the battery with wet hands. Water may cause rust.
    4. Do not touch or move any components inside the transmitter. It may cease to work.

← REMOVAL (May 2007 – Jun 2010)INSPECTION (May 2007 – Jun 2010) →