HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
The intelligent tester is used in steps 2, 3, 4, 6 and 9.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CONNECT INTELLIGENT TESTER TO DLC3 |
- HINT:
- If the display indicates a communication fault in the tester, inspect the DLC3.
| |||||
| 3.CHECK DTC AND FREEZE FRAME DATA |
Check for DTC(s) and freeze frame data (Click here).
- HINT:
- Record or print the DTCs and freeze frame data, if needed.
| |||||
| 4.CLEAR DTC AND FREEZE FRAME DATA |
| |||||
| 5.CONDUCT VISUAL INSPECTION |
| |||||
| 6.SET CHECK MODE DIAGNOSIS |
| |||||
| 7.CONFIRM PROBLEM SYMPTOMS |
- HINT:
- If the engine does not start, perform steps 10 and 12 first.
- Result:
Result
Proceed to
Malfunction does not occur
A
Malfunction occurs
B
|
|||||
| |||||
| 8.SIMULATE SYMPTOMS |
| |||||
| 9.CHECK FOR DTCS |
Check for DTCs (Click here).
- Result:
Result
Proceed to
Trouble code
A
No code
B
|
|||||
| |||||
| 10.REFER TO DTC CHART |
| |||||
| 11.CONDUCT BASIC INSPECTION |
- Result:
Result
Proceed to
Malfunctioning parts not confirmed
A
Malfunctioning parts confirmed
B
|
|||||
| |||||
| 12.REFER TO PROBLEM SYMPTOMS TABLE |
- Result:
Result
Proceed to
Malfunctioning circuit confirmed
A
Malfunctioning parts confirmed
B
|
|||||
| |||||
| 13.CHECK ECM POWER SOURCE CIRCUIT |
| |||||
| 14.CONDUCT CIRCUIT INSPECTION |
- Result:
Result
Proceed to
Malfunction not confirmed
A
Malfunction confirmed
B
|
|||||
| |||||
| 15.CHECK FOR INTERMITTENT PROBLEMS |
| |||||
| 16.CONDUCT PARTS INSPECTION |
| |||||
| 17.IDENTIFY PROBLEM |
| |||||
| 18.ADJUST AND/OR REPAIR |
| |||||
| 19.CONDUCT CONFIRMATION TEST |
| |||||