DTC CHECK / CLEAR
Troubleshooting · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
- NOTICE:
- Intelligent tester only:
- When the diagnosis system is changed from normal mode to check mode or vice-versa, all DTCs and freeze frame data recorded in normal mode will be erased. Before changing modes, always check and make a note of DTCs and freeze frame data.
| CHECK DTC |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the intelligent tester on.
Select the following menu items: Powertrain / Engine and ECT / DTC.
Check for DTCs and freeze frame data, and then write them down.
- HINT:
- If you need help using the intelligent tester, refer to the instruction manual.
Confirm the details of the DTCs (Click here).
| FREEZE FRAME DATA |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the intelligent tester on.
Read DTCs by selecting the following menu items: Powertrain / Engine and ECT / DTC.
Select a parameter(s) to check the freeze frame data.
Note down the DTC(s) and freeze frame data.
- HINT:
- If you need help using the intelligent tester, refer to the instruction manual.
| CLEAR DTCS AND FREEZE FRAME DATA (using the intelligent tester) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) (do not start the engine) and turn the intelligent tester on.
Select the following menu items: Powertrain / Engine and ECT / DTC / Clear.
Erase the DTCs and freeze frame data by pressing the YES button on the tester.
- HINT:
- If you need help using the intelligent tester, refer to the instruction manual.
| CLEAR DTCS AND FREEZE FRAME DATA (not using the intelligent tester) |
Remove the EFI No. 1 and ETCS fuses from the engine room relay block for more than 60 seconds, or disconnect the negative battery cable for more than 60 seconds.