2007-2013 Highlander Kluger · Service Manual ENGINE

BASIC INSPECTION

Troubleshooting · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

When a malfunction is not confirmed by the DTC check, troubleshooting should be carried out in all the circuits considered possible causes of the problem. In many cases, by carrying out the basic engine check shown in the following flowchart, the location of the problem can be found quickly and efficiently. Therefore, using this check is essential in engine troubleshooting.

1.CHECK BATTERY VOLTAGE

    NOTICE:
    Carry out this check with the engine stopped and ignition switch off.

    Result:
    Result
    Proceed to
    11 V or more
    OK
    Below 11 V
    NG


NG.
OK

2.CHECK IF ENGINE CRANKS

    NG.
    OK

    3.CHECK IF ENGINE STARTS

      NG.
      OK

      4.CHECK AIR FILTER
      1. Visually check if the air filter is not contaminated with dirt or oil.


      NG.
      OK

      5.CHECK IDLING SPEED
      1. Check the idling speed (Click here).


      NG.
      OK

      6.CHECK FUEL PRESSURE
      1. Check the fuel pressure (Click here).


      NG.
      OK

      7.CHECK FOR SPARKS
      1. Check for sparks (Click here).


      NG.
      OK

      ← BASIC INSPECTION (Aug 2008 – Jun 2010)PROBLEM SYMPTOMS TABLE (May 2007 – Jul 2008) →