BASIC INSPECTION
Troubleshooting · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
When a malfunction is not confirmed by the DTC check, troubleshooting should be carried out in all the circuits considered possible causes of the problem. In many cases, by carrying out the basic engine check shown in the following flowchart, the location of the problem can be found quickly and efficiently. Therefore, using this check is essential in engine troubleshooting.
| 1.CHECK BATTERY VOLTAGE |
- NOTICE:
- Carry out this check with the engine stopped and ignition switch off.
- Result:
Result
Proceed to
11 V or more
OK
Below 11 V
NG
|
|||||
| |||||
| 2.CHECK IF ENGINE CRANKS |
|
|||||
| |||||
| 3.CHECK IF ENGINE STARTS |
|
|||||
| |||||
| 4.CHECK AIR FILTER |
Visually check if the air filter is not contaminated with dirt or oil.
|
|||||
| |||||
| 5.CHECK IDLING SPEED |
Check the idling speed (Click here).
|
|||||
| |||||
| 6.CHECK FUEL PRESSURE |
Check the fuel pressure (Click here).
|
|||||
| |||||
| 7.CHECK FOR SPARKS |
Check for sparks (Click here).
|
|||||
| |||||