B2281 "P" Signal Malfunction
Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
The ECM and the shift lock control ECU are connected by a cable and the CAN. If the cable information and CAN information are inconsistent, this DTC will be output.- HINT:
- After the main body ECU is replaced, perform the registration procedure for the engine immobiliser system.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2281 |
Cable information and CAN information between main body ECU and shift lock control ECU are inconsistent |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the intelligent tester main switch on.
Read the DATA LIST according to the displays on the tester.
Body: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
SHIFT P SIG
Shift P Signal / ON or OFF
ON: Shift P signal ON (Shift position is P)
OFF: Shift P signal OFF (Shift position is not P)
-
- OK:
- "ON" (P signal is ON) and "OFF" (P signal is OFF) appear on the screen.
|
|
||||
| OK | |
| 2. CHECK WIRE HARNESS (MAIN BODY ECU - SHIFT LOCK CONTROL ECU) |
Disconnect the D9 and D18 ECU connectors.


Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Terminal No. (Symbol)
Condition
Specified Condition
D9-2 (P) - D18-11 (P2)
Always
Below 1 Ω
D9-2 (P) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 3. CHECK MAIN BODY ECU OPERATION |
After replacing the main body ECU with a normally functioning one, check that the engine can start normally.
- OK:
- Engine can start normally.
|
|
||||
| OK | ||
| ||
