2007-2013 Highlander Kluger · Service Manual ENGINE

B2281 "P" Signal Malfunction

Diagnostic trouble codes · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The ECM and the shift lock control ECU are connected by a cable and the CAN. If the cable information and CAN information are inconsistent, this DTC will be output.

HINT:
After the main body ECU is replaced, perform the registration procedure for the engine immobiliser system.

DTC No.
DTC Detection Condition
Trouble Area
B2281
Cable information and CAN information between main body ECU and shift lock control ECU are inconsistent
  1. Main body ECU (Instrument panel junction block)
  2. Shift lock control ECU
  3. Wire harness or connector

WIRING DIAGRAM

B176818E07

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the intelligent tester main switch on.

  1. Read the DATA LIST according to the displays on the tester.

    Body: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    SHIFT P SIG
    Shift P Signal / ON or OFF
    ON: Shift P signal ON (Shift position is P)
    OFF: Shift P signal OFF (Shift position is not P)
    -

    OK:
    "ON" (P signal is ON) and "OFF" (P signal is OFF) appear on the screen.



NG
GO TO SHIFT CONTROL SYSTEM (Click here)
OK


2. CHECK WIRE HARNESS (MAIN BODY ECU - SHIFT LOCK CONTROL ECU)
  1. Disconnect the D9 and D17 ECU connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Terminal No. (Symbol)
    Condition
    Specified Condition
    D9-2 (P) - D17-7 (P2)
    Always
    Below 1 Ω
    D9-2 (P) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK MAIN BODY ECU OPERATION
  1. After replacing the main body ECU with a normally functioning one, check that the engine can start normally.

    OK:
    Engine can start normally.



NG
REPLACE SHIFT LOCK CONTROL ECU (Click here)
OK

END (MAIN BODY ECU DEFECTIVE)


← B2281 "P" Signal Malfunction (Aug 2008 – Jun 2010)B2282 Vehicle Speed Signal Malfunction (+ B2283) (May 2007 – Jul 2008) →