2007-2013 Highlander Kluger · Service Manual ENGINE

B2276 ACCR Signal Circuit Malfunction

Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The main body ECU will set this DTC if the ACCR signal sent from the ECM is ON for 40 seconds or more.

HINT:
If the main body ECU is replaced with a new one while the negative (-) battery terminal is connected, the power source mode will be in IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU is replaced, perform the registration procedure for the engine immobiliser system.

DTC No.
DTC Detection Condition
Trouble Area
B2276
ACCR output circuit inside main body ECU or other related circuit is malfunctioning
  1. Main body ECU (Instrument panel junction block)
  2. ECM
  3. Wire harness or connector

WIRING DIAGRAM

B176786E06

INSPECTION PROCEDURE


1. CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

    HINT:
    After all DTCs are cleared, check if the trouble occurs again 50 seconds after the engine switch is turned on (IG).

  1. Check for DTCs again.

    OK:
    No DTC B2276 is output.



NG
Go to step 2
OK

USE SYMPTOM METHOD TO CHECK (Click here)

2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM)

  1. Disconnect the D6 ECU connector.B176967E02

  1. Disconnect the D31 ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D6-3 (ACCR) - D31-17 (ACCR)
    Always
    Below 1 Ω
    D6-3 (ACCR) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT MAIN BODY ECU

  1. B138007E15
    Reconnect the D6 and D31 connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D6-3 (ACCR) - Body ground
    Brake pedal depressed, shift P position, engine switch is pushed once → on (IG)
    0.1 to 0.8 V (*1) → output voltage at terminal AM1 or AM2 is -2 V or more.

    HINT:
    *1: Voltage is output only when the engine is cranking.



NG
REPLACE ECM (Click here)
OK


4. CHECK MAIN BODY ECU OPERATION
  1. After replacing the main body ECU with a normally functioning ECU, check that the engine starts. Make sure the brake pedal is depressed and the shift position is P at this time.

  1. Check that the engine switch mode can be changed by pushing the engine switch.

    HINT:
    Without depressing the brake pedal, push the engine switch repeatedly. Engine switch mode should turn from off to on (ACC) to on (IG) and back to off. With the brake pedal depressed, push the engine switch repeatedly. Engine switch mode should turn to ENGINE START from any status.

    OK:
    Engine starts normally.



NG
REPLACE ECM (Click here)
OK

END (MAIN BODY ECU DEFECTIVE)


← B2276 ACCR Signal Circuit Malfunction (May 2007 – Jul 2008)B2276 ACCR Signal Circuit Malfunction (from Jul 2010) →