B2276 ACCR Signal Circuit Malfunction
Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
The main body ECU will set this DTC if the ACCR signal sent from the ECM is ON for 40 seconds or more.- HINT:
- If the main body ECU is replaced with a new one while the negative (-) battery terminal is connected, the power source mode will be in IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
- After the main body ECU is replaced, perform the registration procedure for the engine immobiliser system.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2276 |
ACCR output circuit inside main body ECU or other related circuit is malfunctioning |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK DTC OUTPUT |
Delete the DTCs (Click here).
- HINT:
- After all DTCs are cleared, check if the trouble occurs again 50 seconds after the engine switch is turned on (IG).
Check for DTCs again.
- OK:
- No DTC B2276 is output.
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM) |
Disconnect the D6 ECU connector.


Disconnect the D31 ECM connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
D6-3 (ACCR) - D31-17 (ACCR)
Always
Below 1 Ω
D6-3 (ACCR) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 3. INSPECT MAIN BODY ECU |
Reconnect the D6 and D31 connectors.

Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
D6-3 (ACCR) - Body ground
Brake pedal depressed, shift P position, engine switch is pushed once → on (IG)
0.1 to 0.8 V (*1) → output voltage at terminal AM1 or AM2 is -2 V or more.
- HINT:
- *1: Voltage is output only when the engine is cranking.
|
|
||||
| OK | |
| 4. CHECK MAIN BODY ECU OPERATION |
After replacing the main body ECU with a normally functioning ECU, check that the engine starts. Make sure the brake pedal is depressed and the shift position is P at this time.
Check that the engine switch mode can be changed by pushing the engine switch.
- HINT:
- Without depressing the brake pedal, push the engine switch repeatedly. Engine switch mode should turn from off to on (ACC) to on (IG) and back to off. With the brake pedal depressed, push the engine switch repeatedly. Engine switch mode should turn to ENGINE START from any status.
- OK:
- Engine starts normally.
|
|
||||
| OK | ||
| ||
