2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

DIAGNOSTIC TROUBLE CODE CHART

Diagnostic trouble codes · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

If a normal system code is displayed during the DTC check, but the problem still occurs, check the circuits for each problem symptom in the order given in the table below and proceed to the relevant troubleshooting page.

HINT:
  1. The following is the troubleshooting procedure for the wireless door lock control of a vehicle with the smart entry and start system.
  2. For the troubleshooting procedure for the wireless door lock control of a vehicle with the smart entry and start system, refer to the wireless door lock control system (w/ Smart Entry and Start System).
  3. Inspect the fuse and relay before investigating the suspected areas shown in the table below.
  4. Use the table below to help determine the cause of a problem. The likely causes of the problem are indicated in descending order. Check each suspected area in order. Repair or replace faulty parts or perform adjustments as necessary.

WIRELESS DOOR LOCK CONTROL SYSTEM: 
DTC Code
Detection Item
Trouble Area
See page
B1242
Wireless Door Lock Tuner Circuit Malfunction
1. Door control receiver
2. Wire harness
3. Main body ECU
Click here
← DIAGNOSTIC TROUBLE CODE CHART (Aug 2008 – Jun 2010)B1242 Wireless Door Lock Tuner Circuit Malfunction (May 2007 – Jul 2008) →