B1242 Wireless Door Lock Tuner Circuit Malfunction
Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
The door control receiver receives signals from the transmitter and sends these signals to the main body ECU.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B1242 |
In diagnostic mode, an applicable RDA signal cannot be received within 1 second after a PRG signal has been output from the main body ECU. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - DOOR CONTROL RECEIVER) |
for LHD:
Disconnect the D6 main body ECU connector and the O28 door control receiver connector.


Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
D6-12 (RDA) - O28-2 (RDA)
Always
Below 1 Ω
D6-12 (RDA) - Body ground
Always
10 kΩ or higher
D6-10 (PRG) - O28-3 (PRG)
Always
Below 1 Ω
D6-10 (PRG) - Body ground
Always
10 kΩ or higher
for RHD:
Disconnect the D6 main body ECU connector and the O38 door control receiver connector.


Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
D6-12 (RDA) - O38-2 (RDA)
Always
Below 1 Ω
D6-12 (RDA) - Body ground
Always
10 kΩ or higher
D6-10 (PRG) - O38-3 (PRG)
Always
Below 1 Ω
D6-10 (PRG) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (BATTERY, BODY GROUND) |
for LHD:
Measure the voltage and resistance according to the value(s) in the table below.

- Standard:
Tester Connection
Condition
Specified Condition
O28-1 (GND) - Body ground
Always
Below 1 Ω
O28-5 (+B) - Body ground
Always
11 to 14 V
for RHD:
Measure the voltage and resistance according to the value(s) in the table below.

- Standard:
Tester Connection
Condition
Specified Condition
O38-1 (GND) - Body ground
Always
Below 1 Ω
O38-5 (+B) - Body ground
Always
11 to 14 V
|
|
||||
| OK | |
| 3. REPLACE DOOR CONTROL RECEIVER |
Reconnect the D6 main body ECU connector.
Replace the door control receiver with a normal one (Click here).
Perform the registration procedures (Click here).
- HINT:
- If a normally functioning door control receiver is available, connect it and check if the wireless door lock function is normal or DTCs are output. If the alternative receiver functions normally, replace the original door control receiver.
| NEXT | |
| 4. CONFIRM DTC |
Clear the DTCs (Click here).
Check if the same DTC is detected.
- HINT:
- Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.
- Result:
Result
Proceed to
DTC is output
A
DTC is not output
B
|
|
||||
| A | ||
| ||
