B1620/21 Side Airbag Sensor RH Circuit Malfunction
Diagnostic trouble codes · Vehicles built from Jul 2010
DESCRIPTION
The side collision sensor RH circuit (to determine deployment of the front seat side airbag assembly RH and curtain shield airbag assembly RH) is composed of the center airbag sensor assembly, side airbag sensor RH and rear airbag sensor RH.The side airbag sensor RH detects impacts to the vehicle and sends signals to the center airbag sensor assembly to determine if the airbag should be deployed.
DTC B1620/21 is stored when a malfunction is detected in the side airbag sensor RH.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B1620/21 |
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK SIDE AIRBAG SENSOR RH |
Turn the ignition switch off.

Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Interchange the side airbag sensor LH with the side airbag sensor RH and connect the connectors to them.
Connect the cable to the negative (-) battery terminal.
Turn the ignition switch on (IG), and wait for at least 60 seconds.
Clear the DTCs stored in the memory (Click here).
Turn the ignition switch off.
Turn the ignition switch on (IG), and wait for at least 60 seconds.
Check for DTCs (Click here).
- Result:
Result
Proceed to
DTCs B1620/21 and B1625/22 are not output.
A
DTC B1625/22 is output.
B
DTC B1620/21 is output.
C
- HINT:
- Codes other than DTCs B1620/21 and B1625/22 may be output at this time, but they are not related to this check.
|
|
||||
|
|
||||
| A | ||
| ||
